How to Program Your Genie 3-Button Remote – Model G3T

How to Program Your Genie 3-Button Remote – Model G3T

The popular G3T Genie garage door opener remote features Genie Intellicode Technology which keeps your garage secure by changing the access code every fourth dimension you apply it.  This opener works with upwards to 3 Genie garage door openers manufactured from 1997-present.  The top 2 buttons of the G3T remote will work with Genie garage door openers manufactured from 1995-1997.

Y'all can as well program your Genie G3T Remote to your built-in car wireless control systems, HomeLink or Car2U.  This Genie garage door opener remote replaces the onetime remotes pictured below.

Follow the below instructions on how to programme your Genie G3T garage door opener remote.

A video with footstep-by-footstep instructions can exist found here.

PDF Instructions found here.

Genie g3t

Step i - Putting the Garage Door Opener into Programming Fashion

New Genie® Garage Door Openers

1. Press and hold the program button until the round LED turns blue, so release.

2. The minor round LED light will go out and the long LED will begin flashing purple.

Proceed to pace 2.

                                -OR-

Genie® Openers and External Add On Receivers that were Manufactured betwixt 1995 to 2011

i. Locate the Genie garage door opener learn button. Printing & Release the Learn Lawmaking push button once. The carmine LED volition begin to flash.

Proceed to step two.

Step 2- Programming the (G3T) 3-Push Remote to your Garage Door Opener

NOTE: Once in programming mode, you volition have approximately 30 seconds to perform this step

i. Pull the protective battery tab from the remote.

Image removing pull tab from a new G3T-R Genie remote

Annotation: While programming remote buttons, stand at least 5 feet away from the opener. This ensures you have proper advice between the remote and the opener.

2. Slowly press and release the remote button of your option two times. The opener LEDs will flash and go off, indicating y'all have successfully programmed your remote.

3. Printing and release the aforementioned button a 3rd time and door will open or close. It is possible to press the remote button too quickly or lightly. If the LEDs do not go OFF, press the remote button several more times to attain confirmation.

Lost or Stolen Remote/Erasing all Remotes

Newer Genie® Garage Door Openers

1. Press and hold the program push until the circular LED turns blue, and so release.

2. Printing and hold the Up(+) Down (-) buttons at the aforementioned time, until both LEDs flash blue and become OFF.

Genie® Garage Door Openers and External Receivers Manufactured between 1995 to 2011

• To erase all of the remote devices from other types of Genie® garage door openers, Press and hold the Acquire Lawmaking Push button until the LED stops blinking.

Start at step 1 to reprogram your remotes.

Note: Immigration remote command memory from the power caput will clear ALL programmed remotes and keypads. Your opener will no longer recognize whatsoever signal from whatsoever remote device, including a missing remote device.

Replacing the Remote Battery

Supervene upon the G3T remote battery with CR2032 coin cell battery.

one. Open up the remote case using a washer or money that fits into the slot at the top of the remote.

Image replacing battery on a G3T-R Genie 3 Button remote

2. Replace the bombardment. Lucifer bombardment polarity symbols within the battery housing.

3. Align components and snap case closed.

NOTE: For openers manufactured between 1995-1997, apply the ii upper buttons on the remote. Made later 1997 - use any push for programming.